This article covers some advanced programming with the 2GIG Smart Thermostat.
Do Not Take Any Of These Actions Without Confirming With Property Management.
TABLE OF CONTENTS
- Z Wave Plus V2 Quick Guide
- Heat Pump w/ Aux Heat
- Reversing Valve (O/B)
- Aux Heat Enable
- Heat Stage 2 On Threshold
Z Wave Plus V2 Quick Guide
1. Before removing the old thermostat, cut power from furnace/air handler via breaker, or disconnect.
2. Install new sub base, conventional wiring:
- Red-R,
- Green-G,
- White-W1,
- Yellow- Y1.
- If no "C' wire is present, use supplied batteries.
3. Default program settings are for conventional systems. No changes needed.
Heat Pump w/ Aux Heat
- The Heat Pump wiring should be as follows:
- Red-R
- Green-G
- Yellow-Y1
- Orange- O/B
- White-AUX/E
- C (color varies)
- Push and hold MODE Button until you see SETUP on the screen.
- Use Up/Down buttons to find SYSTEM, then push FAN (Select) button.
- Use Up/Down buttons to find the SYSTEM TYPE option, then push FAN (Select) button.
- Use Up/Down buttons to find the HEAT PUMP option.
- Push FAN (Select) button to choose the HEAT PUMP option, then push MODE (Done) button to save.
Reversing Valve (O/B)
- Push and hold MODE Button until you see SETUP on the screen.
- Use Up/Down buttons to find SYSTEM, then push FAN (Select) button.
- Use Up/Down buttons to find CHANGEOVER TYPE option. Press FAN (Select) button.
- Use Up/Down buttons to find the WITH HEAT or WITH COOL option, depending on the make of the unit.
- Cycle the unit on and if running "backwards" switch selection.
- Press MODE (Done) button to save.
Aux Heat Enable
- Enter initial programming, press and hold the MODE button for 5 seconds until you see SETUP on the screen.
- Continue with Up or Down buttons to AUX HEAT ENABLE, followed by pressing Select button.
- Press the Up or Down Arrow buttons until you see 'Y', press Select again to lock in the choice.
- Press Done to save.
Heat Stage 2 On Threshold
- Enter initial programming, press and hold the MODE button for 5 seconds until you see SETUP on the screen.
- Continue with Up or Down buttons to HEAT STAGE 2 ON THRESHOLD, followed by pressing Select button.
- Press the Up or Down Arrow buttons until you see 'Y', press Select again to lock in the choice.
- Press Done to save.
NOTE: If you are using a C wire, the thermostat will not work with batteries. Remove batteries and rely on transformer to power the thermostat.