1. To begin pairing the GoControl thermostat to the Propify hub, press the Add Device button on the Propify installation Guide.


2. Under "Available Devices to Pair", select GoControl Thermostat.  Press continue until you reach the "Exclusion Mode" screen. 



3. To access the thermostat's settings, press and hold the FAN button on the button left side until you see "Setup" appear on the thermostat screen. 

  • This may take up to 5 seconds. 




4. To access the Z-Wave pairing menu, press the arrows on the right hand side to scroll down until you see the "Z-Wave" option on the screen.  




5. Once you see "Z-Wave" on the screen, press the MODE button on the top-left corner to enter the menu. 

  • If the screen says "Remove", continue to step 6. 

  • If the screen says "Install", skip to step 8.


6. On the Propify Installation page, press the Exclusion Mode button.  The Propify Hub will search for a device that can be cleared of any additional pairings.  Since a thermostat can only be paired to one hub at a time, this step must be taken.   



7. On the thermostat screen, press the MODE button on the top-left corner.  At this point, the thermostat will visually flash between "Wait" and "Excluding" before displaying the final result.   
  • If the thermostat says "Success", you can press MODE and continue to step 8.  
  • If the thermostat said "Failed", press Done and repeat steps 3-7.   


8. Press Continue on the Propify Installation screen to reach the Inclusion Mode page and press the Inclusion MODE button. The Propify Hub will now begin broadcasting a signal that allows another devices to connect to the Hub.

   


9. On the thermostat's Z-Wave screen, press the MODE button to see the message that reads "Install".  Press Select on the thermostat.   



  • The thermostat will begin flashing between "Wait" and "Install" for about 30 seconds before visually displaying a final result.   
    • If the thermostat says "Success", you may press the Fan button on the thermostat.  At this point, the Propify Installation page will re-direct you to the home screen.  
    • If the process failed, the thermostat screen will say "Failed".  At this point, please retry steps 3-5 and 8-9.   



Once the device is paired, Verify Your System Is Completely Paired.


If the thermostat pairing process continues to fail, Click Here.