- Note: the Propify Installation Guide will be updated with multiple lock models, so you may ignore the current lock name and photos in the Installation Guide. The steps below will guide you through this process.
2. Under "Available Devices to Pair", select Yale YRD100 Smart Lock.
3. Remove the battery cover from the Kwikset lock. You can do this by sliding the Kwikset cover upwards on the deadbolt side of the lock.
4. On the Propify Installation Guide, press the Exclusion Mode button. The Propify Hub will search for a device that can be cleared of any additional pairings. Since a lock can only be paired to one hub at a time, this step must be taken.
5. On the Kwikset lock, press the button under the letter "A". The lock will display a red light to indicate it is now looking for a command from a Z-Wave hub. Once the red light goes away, continue to step 6.
6. Press Continue on the Propify Installation Guide screen to see the "Inclusion Mode" screen. On this screen, press the Inclusion Mode button. The Propify Hub will now begin broadcasting a signal that allows another devices to connect to it.
On the Kwikset lock, press the button under the letter "A". Again, the light will turn red. Once the pairing is complete, the light will turn off and your Propify Installation page will redirect you to the home screen.
If this light stays lit and your Propify Installation page does not change after 60 seconds, retry steps 3-6.
Once the lock is paired move on to Available Thermostats.
If the lock is not connecting after multiple attempts, Click Here.